Látex Líquido para Moldes

Liquid Latex for Molds

204420001
€11.00
13,31 € IVA incl.
  • Latex to make molds, dolls, characterization make-up, scenery, etc...
  • Its viscosity is low (like milk) allowing to achieve maximum detail.
weight
  • 1 kg
  • 5 kg
  • 25 kg

 

Monocomponent ammonia-based liquid latex to make molds, dolls, characterization make-up, scenography, etc...

Its viscosity is low (like milk) allowing to achieve maximum detail.

Compatible with Feroca latex paints

USE IN CASTING MOLDS:

  1. Have the mold dry (the drier the better).

  2. Fill the mold with liquid latex and leave it for approximately 10 minutes.

    Empty it and wait until it is semi-dry.

  3. If the desired thickness is not obtained, repeat the operation as many times as necessary.

USE OF LATEX BY IMMERSION IN POROUS MOLD:

  1. The piece of plaster should be as dry as possible and free of dirt (grease, dust, etc.).

  2. The latex where the piece is going to be immersed must have rested until deaerated.

  3. The surface of the latex must be cleaned of foam, dust, etz.

  4. The immersion time will be determined by the desired latex thickness.

  5. Once the latex has been used, it should be filtered and stored in a separate container from the unused latex

    unused latex.

  6. The piece will be demolded when when pulling the rubber, this does not suffer variation of color

    color.

ALWAYS USE ADEQUATE PROTECTION, IT CONTAINS AMMONIA SOURCE AND LATEX

NOT SUITABLE FOR CONTACT WITH HUMAN SKIN, USE LATEX FOAM FOR THAT PURPOSE

No reviews

You might also like

Product added to wishlist
Cookie consent