Ferosil V 32 Silicone Paste Release Agent for Silicones
3,87 € IVA incl.
EASYCLEAR is atwo component (parts A and B) translucent siliconeelastomerthat cures at room temperature, the base (part A) has the appearance of atranslucent viscous liquid which, after theaddition of EASYCAT-20 catalyst (part B), transforms into anelastic material. It exhibits exceptional flowability and good workability.
EASYCLEAR is recommended for the application of molds for Plaster, Polyester Resin, Polyurethane Resin, Epoxy Resin, Fiberglass, Wax, Soap, Bronze, etc. casts.
As it is a soft silicone rubber with low viscosity, it is suitable for molds with complicated hollows that are difficult to demold.
Due to its translucency it is perfect for block molds or as a material for hyper-realistic parts.
INSTRUCTIONS:
1- Prepare the box for the mold and the original.
2- Set aside 100 parts of the base (Part A) and add 5 parts of catalyst (Part B) mix VERY well both parts until a homogeneous mixture is obtained.
3- Pour the silicone casting into the box or apply with a brush if it has been previously thixotropic .
NOTE: Normally low hardness silicone is used for molds of casting, since it allows a better demolding and thus does not damage the original .
Product |
Proportion Mixing ratio |
Curing Time |
Breaking Strength |
Viscosity of the mixture |
Working Time |
Shore Hardness A |
Tensile Strength |
Color |
EASYCLEAR |
100:5 (5% catalyst) |
4-5 hours | 400% | 13000 cps | 20 min. | 20 | 33 Kgf/cm | Translucent |
ONE-SIDED SILICONE MOLD
DOUBLE-SIDED SILICONE MOLD
MOULD WITH PINCEL by SIMBIOX
You might also like